Thursday 18 April 2013

How To Update The Firmware Version Of Samsung S6810 Galaxy Fame, And S6810P Galaxy Fame NFC

Files and Programs:
- Original USB cable for Samsung Galaxy Fame, Or any suitable one.
- A computer running Windows OS.

Samsung Galaxy Fame Firmware Update Steps:
- After downloading the needed files and programs, Extract any zipped one, And install the USB drivers, Then it is better to restart your computer.
- Check your phone's battery (Must be at least at 90%).
- Turn Off the phone.
- Take out the phone's battery, SIM card, And memory card too.
- Run Odin.exe flasher program.
- Auto Reboot, F.Reset Time options must be checked.
- In case you need to flash *.PIT file too, Then check Re-Partition option.
- Click on PIT button and select: nevisp.pit file (only when Re-Partition is checked).
- Now you are going to select the firmware files from its extracted folder:

Click Bootloader button to select: BOOT_S6810xxxxxx_REV00.tar.md5
Click PDA button to select: CODE_S6810xxxxxx_xxxx_REV00_...tar.md5
Click PHONE button to select: MODEM_S6810xxxxxx_REV00.tar.md5
Click CSC button to select: CSC_Oxx_S6810xxxxxx_xxxx_REV00_...tar.md5

- Put the phone's battery back, But do not turn it on.
- To put the Galaxy Fame into Download Mode you have to:

Press and Hold Volume Down key + Home key, Then press Power key.

- Connect it to the computer via the USB cable, And wait for it to be detected.
- Odin will detect the Com number of your phone, It will look like this 0:[COMxx].
- Click on Start button.
- Odin program will start installing the selected firmware files into your Galaxy Fame.
- You have to wait for some minutes, But don't interrupt the process at all.
- Your phone will be rebooted after the process is done.
- If it was a successful update, You will see PASS! word at Odine's window.
- Disconnect the USB cable from phone.
- When your phone is fully on, You can do a full reset by this code *2767*3855#

Notices:
- When you have one file inside the firmware update package, Then don't check Re-Partition option, And don't select any PIT file. The one file must be selected as PDA file.

No comments:

Post a Comment