How To Update Samsung S5301 Galaxy Pocket Plus Firmware Using Odin Program

Firmware Update Steps:

- Turn off your Galaxy Pocket Plus and take out its battery, SIM card, And MMC card.

- Run Odin.exe program.

- You will notice that Auto Reboot and F.Reset Time options are checked, Leave them as they are.

- In case you have or need to flash *.PIT file then check Re.Partition option, Otherwise leave it unchecked.

- In the next steps you will select the needed firmware files from the extracted firmware folder.

- Click PIT button and select the S5301 *.pit file (If you checked Re.Partition option).
- Click PDA button to select CODE_S5301xxxxxx_...REV02_...tar.md5
- Click PHONE button to select MODEM_S5301xxxxxx_...REV02_....tar.md5
- Click CSC button to select CSC_Oxx_S5301xxxxxx_...REV02_....tar.md5

- In case you have only one big file inside the firmware package, Then you need to select it as PDA file, And never check Re.Partition option or use *.pit file.

- Put the battery back into your phone, But do not turn it on.

- You should put the phone into Download Mode, Do these steps for that:

Press and Hold Volume Down key + Home key, Then press Power key.

- Connect the phone to your PC using the USB cable.

- If windows starts to install any drivers then wait until it is done.

- Odin program must detect your phone to be able to update it, So look at it and if you see 0:[COMxx] when xx are numbers then it is OK.

- Click on Start button.

- Odin will start installing the new firmware files on your Galaxy Pocket Plus.

- After Odin completes his job, Your phone will be rebooted.

- If you see the word PASS! at Odin's window then the update was done successfully.

- Disconnect the USB cable from your phone.

- When your phone is fully on it is better to do full reset by this code *2767*3855#

- You have to wait one more time for your phone to reboot, Then you can start using it with the new firmware installed.